Originally Posted by Gamalier
You can install a wing tube. It will be tricky but its possible. You can cut a small hole thru the carbon fiber. Then get an aluminum tube and cut notches in one of the ends to use it as a drill. Set the wing equally spaced to allow to the tube to be centered. You can build support wedges out of balsa or foam (just like a shuck). The only part you might not like is the removing of a little slice of the wing to allow the cutting of the inner part of the foam inside the wing.
I was thinking about it but each of the wing panels are only 12.5" long (stubby little wings).