Thread: Discussion Drilling carbon props
View Single Post
Old Nov 18, 2012, 08:23 PM
whyrudy is offline
Find More Posts by whyrudy
¿Por Qué No?
United States, OR, Salem
Joined Aug 2011
30 Posts
Discussion
Drilling carbon props

I have a couple of PT props and need to enlarge center hole from 6mm to 8mm. I’ve never drilled in carbon before and better safe than sorry. I have an 8mm drill and always use a backing board for drill through most materials. What have you done?
whyrudy is offline Find More Posts by whyrudy
Reply With Quote