View Single Post
Old Nov 18, 2012, 03:39 PM
Boris13 is offline
Find More Posts by Boris13
Registered User
Joined Oct 2012
39 Posts
Forgot how it came apart

Good evening,

I just stripped down and rebuilt my Lama V3 tonight - it's basically a V4 in an Alouette Lama body, as you probably know..

When replacing the main gear on the bottom of the 4mm shaft there's a small brass washer that sits either above or below the 4x8x3mm bearing.
(The washer isn't even listed in the exploded diagram that came with the instructions. )

This washer has a ridge on its inside circumference - should that be up or down ?

And I assume the washer goes between the bearing and the main gear wheel right ?
Boris13 is offline Find More Posts by Boris13
Reply With Quote