Thread: Rave Night vapor!
View Single Post
Old Nov 18, 2012, 12:39 PM
Puddytatter is offline
Find More Posts by Puddytatter
Registered User
Joined Nov 2012
45 Posts
I did a search about the J3 Cub motor and came up with a number of posts from people who tried it and liked it. I didn't find any specific information about doing the mod. I checked out the motor at an on-line hobby shop and it said it was 6mm in diameter, but couldn't find any other specs.

Is it correct to say it is the same diameter, but longer and more powerful than the stock vapor motor? Can you just slide the old one out of the existing motor mount and slide the new one in? Does the pinion mesh with the Vapor gear wheel? If it is that easy, I would like to order a couple of them and put one on the Ember 2 as well.
Puddytatter is offline Find More Posts by Puddytatter
Reply With Quote