View Single Post
Old Nov 17, 2012, 12:08 PM
madbugger is offline
Find More Posts by madbugger
Registered User
madbugger's Avatar
Ayrshire, Scotland
Joined Jan 2008
1,118 Posts
chidago/ serves me right for not reading jeep's post carefully enough. He meant the intake On my steve-modded drive I have the stainless grill he supplies - actually made from pieces of stainless wire but it works like a charm. On my stock (Graupner impellered) ones I have used the grill from a cheap electric mosquito swatter as somebody mentioned on the thread a while ago.

Tiernan85/ glad you have found a cure. There must be a tolerance on these things and I'm just lucky my moulding just happened to be fine and it was only the fibre washer that needed modding. As everyone says, allen/cap screws are the only way to go for motor mounting. As I said before is a good place to go for rapid delivery of cheap screws for people in the British Isles.
madbugger is offline Find More Posts by madbugger
Last edited by madbugger; Nov 17, 2012 at 12:48 PM.
Reply With Quote