View Single Post
Old Nov 17, 2012, 11:19 AM
AcroFPV is online now
Find More Posts by AcroFPV
we dont NEED roads!
AcroFPV's Avatar
United States, CA, Rocklin
Joined Aug 2012
3,496 Posts
Here are a few pix of my FPV gear mounted up.

This is whats going on the frame. I got a 800mah 3s battery for the vRX. I didn't want to run the vRX off a 4s, and was thinking a separate battery would reduce interference. The keychain cam is a V2 cam that has video output, while also recording 720p onto a micro-SD card.


Camera is sitting on a chunk of memory foam. Foam is taped to the RX using double sided duct tape. The zip tie holding the camera, is ran through the center of the foam block. I am pretty impressed with the results so far.


I mounted my vRX and battery on the tail. I am not sure if the tail motors will cause interference with the video signal, but it looks good there if you ask me




I'll have to get some pictures of my ground station setup next time I set it all up.
AcroFPV is online now Find More Posts by AcroFPV
Reply With Quote