View Single Post
Old Nov 17, 2012, 10:49 AM
WimH is offline
Find More Posts by WimH
Registered User
WimH's Avatar
Belgium, Flemish Region, Oosterzele
Joined Dec 2001
5,555 Posts
I got my backlight and programmer working reliably by ditching the spring contacts and use soldering instead... until I installed a new revision of my open 9X software, now I'm back to no backlight at all, and I have no clue about what could be wrong...
Can't put on new software at the moment because all wires connecting the board to the usb have let go at the usb connector board... Will replace with more flexible wires and hope someday my troubles will end.... All suggestions welcomed....
Oh, is there a diagram around about what goes where from the board connector to the usb print in the battery compartment?
WimH is offline Find More Posts by WimH
RCG Plus Member
Latest blog entry: That elusive thermal...
Reply With Quote