View Single Post
Old Nov 17, 2012, 09:52 AM
pilot_keeter is offline
Find More Posts by pilot_keeter
Registered User
pilot_keeter's Avatar
United States, GA, Winder
Joined Nov 2008
349 Posts
DG, I noticed you used the outside most hole on the CF arms. A lot of others have mentioned using the inside hole so that the push-rod is more perpendicular and 90 degrees. When using the inside hole, the plastic ball-link cannot swivel freely all the way around. It binds against the end of the plastic servo arm. Will this hinder my throws? Should I move it to the outer most CF arm hole??
pilot_keeter is offline Find More Posts by pilot_keeter
Last edited by pilot_keeter; Nov 17, 2012 at 10:21 AM.
Reply With Quote