View Single Post
Old Nov 17, 2012, 01:56 AM
turrican_1 is offline
Find More Posts by turrican_1
Registered User
Joined Nov 2012
27 Posts
Quote:
Originally Posted by simonk View Post
Hello! Looks the same to me. Assuming they aren't still disabling SPI flashing by setting the RSTDISBL fuse in the factory, it should work if you can flash tp.hex.



You'll know if you're reaching full throttle since it should happen rigth before the top of your stick movement, and going higher/trimming higher should have no effect. There is no possible way that resistance will have any effect, or the ESC would catch on fire. It can only be timing (which should only have a very small effect) or input voltage.



I haven't got any of those yet since they weren't carrying them before, but since the 60A is "bs.hex", I would assume the 50A is, too. You could try and let us know if it works. If not, you should follow this guide to see what it should be.
Hi simonk i have the same problem of acuralegendz with new redbrick 30A
try many firmware but my first esc burning during test.
The pcb of this esc is very similar to birdie 30A pcb
turrican_1 is offline Find More Posts by turrican_1
Reply With Quote