Thread: Discussion Diagonal lines
View Single Post
Old Nov 16, 2012, 11:28 PM
lennie054 is offline
Find More Posts by lennie054
Registered User
The Netherlands, NB, Tilburg
Joined May 2011
35 Posts
I'm going to try and make a new wire harnass. separating all cables from each other to try and find the source, since i used the original connector and a piece of the cable from the pixim cam. And make a new lc filter, since this is the only component i did not exclude. by the way, does it matter if i used both the audio ground and the video ground of the camera? I'm not using audio, but i ran the ground back anyway. I tried disconnecting each one of them. same result.

Tried a torroid as big as my thumb on the ground from the tx, and on theground of the power supply, just behind the regulator. no difference until the top of the picture started to pull to the right..
also tried it on the video line to the tx, did nothing but take away my colours..
lennie054 is offline Find More Posts by lennie054
Reply With Quote