View Single Post
Old Nov 16, 2012, 12:20 PM
AndyCross is offline
Find More Posts by AndyCross
Registered User
Joined Nov 2010
218 Posts

Made an elevator joiner and utilized just one control rod & servo.
Works superb and saves weight and a lot less hassle. Swapped the wheels for 4" black ones. looks a lot nicer.

My only gripe are the spats are a crud/dirt magnet. Any flying off a wet/damp/muddy grass strip results in virtual complete u/c stripdown and clean.

I think this is more of a summer/dry flyer not a winter hack.

Got a nice 16x8 laminate xoar prop to try yet. Powers impressive on 6s with low amps(under 40) and it sounds lovely.
Fettled the dash a little and made a little more period style.

Specs are
pulso 4120-20 470 kv motor
60amp enrgpro sbec +10amp seperate cc bec
6s flightmax zippy 20c lipos
16x8 prop

auw 8lb 9z
wot 1098w @41amps

Standard digital servos.

cofg as per manual , no additional weight needed

AndyCross is offline Find More Posts by AndyCross
Reply With Quote