View Single Post
Old Nov 16, 2012, 08:46 AM
Brandigan is offline
Find More Posts by Brandigan
Suspended Account
Joined Jun 2012
2,902 Posts
Quote:
Originally Posted by obelix662000 View Post
I built 2 mods with Pro Mini and Level shifter exactly as described in the wiring diagram. Both are fine with Ardrone v2 , no special care.
OK, thanks. That's confusing. Any chance you could PM me a photo with your wiring, as this is beyond baffling?

It's clear the Nano and Pro Mini are different because I only get 4.63v from a Nano, but 5.01v from the Pro Mini at VCC>GND (powered through USB), but is that enough to explain the problems I'm having?

The new Nano has turned up, so I'll wire that to the Drone's 12v/GND and measure what's at VCC and what's going back through Tx and Rx with Resistors or another new Level Shifter.
Brandigan is offline Find More Posts by Brandigan
Reply With Quote  (Disabled)