View Single Post
Old Nov 16, 2012, 07:02 AM
madbugger is offline
Find More Posts by madbugger
Registered User
madbugger's Avatar
Ayrshire, Scotland
Joined Jan 2008
1,118 Posts
Quote:
Originally Posted by Tiernan85 View Post
No, tried with the stock screws and some cap head screws I had. I'll take a pic this evening to explain it a bit better.
If you actually meant the motor, as you said, rather than the jet unit then be aware you will damage the motor using such long screws to mount it to the drive. Hence the warning in the blurb on Giantcod's site. Use the screws that came with the motor or, if you want to be able to change the motor later once the jet is sealed back in the hull, it will be easier to undo them from above if you use M2.5 x 5mm allen screws from someone like
http://www.ebay.co.uk/itm/1507373854...84.m1439.l2649

But I'm probably being paranoid. I expect you meant the jetdrive to the hull rather than the motor to the drive, but better safe than sorry
madbugger is offline Find More Posts by madbugger
Last edited by madbugger; Nov 16, 2012 at 07:13 AM.
Reply With Quote