Thread: Build Log AeroSky B60 Build
View Single Post
Old Nov 15, 2012, 10:39 PM
sparkie624 is offline
Find More Posts by sparkie624
Registered User
sparkie624's Avatar
Roanoke, VA
Joined Sep 2008
928 Posts
Quote:
Originally Posted by Cubcrazy View Post
I set all my planes to 100% servo travel and then adjust how much my thumbs move. Setting manufacturer recommended throws is over-rated just as manufacturer CG is often unreliable. Dual rates? Expo? Humbug...
Flaps are a different story. I like to use multiple position flaps, and I usually set them up based on the full size counterpart, then tweak it if I don't like the performance. I have never seen a plane with opposed servos on flaps that didnt require a reversed servo on one side. Only way around it is to mount both servos in the same direction, or get a reverser, or open it up and reverse a servo.

-Cub
Pretty much the same here.. except I used 125% on high and 75% on low rates. For the flaps I set 2 positions. 10 deg and 45 deg, measured with an inclineometer. They are cheap at Harbor Freight.
sparkie624 is offline Find More Posts by sparkie624
Reply With Quote