Thread: Discussion Bobbing motion at full speed.
View Single Post
Old Nov 15, 2012, 10:22 PM
Pseudonym is offline
Find More Posts by Pseudonym
Registered User
Pseudonym's Avatar
Joined Apr 2012
280 Posts
Your problem is typically caused by one of a few things:
-Too much positive prop angle
-Prop to low
-incorrect prop

Change your stinger/strut so that it is more towards the negative end of the spectrum (prop pointing down) and see if this fixes your problem. I would not try to fix the problem with trim tabs, as that will create a lot of additional drag.
Pseudonym is offline Find More Posts by Pseudonym
Reply With Quote