Thread: Discussion Hobby city epo ventus
View Single Post
Old Nov 15, 2012, 11:01 AM
SuperCub Man is offline
Find More Posts by SuperCub Man
Registered User
Joined Apr 2005
39 Posts
With any that I have had there is a circlip and washer on one end and the grub screw on the other. After removing both I gently tap one end with a light hammer until it moves - usually pushing it through from one side to the other. The shaft is a very tight fit. Then I replace the circlip which is now on the prop end of the shaft in a new groove and tighten the grub screw. Usually there are two grooves on the shaft for the circlip so this move can be accomplished. Drill a hole in a piece of wood - or your bench - that the shaft can slide into while the wood supports the bell or casing while you're "tapping" it!.
You're on your own - but I've done many this way.
SuperCub Man is offline Find More Posts by SuperCub Man
Reply With Quote