Thread: Discussion Blade 450 3d
View Single Post
Old Nov 14, 2012, 11:54 PM
Wookster is offline
Find More Posts by Wookster
Augernaut
Wookster's Avatar
United States, KS, Overland Park
Joined Jan 2010
1,525 Posts
Let me throw some words of advice in here. For the FP to 450 guy. The best thing you can do, and I speak of this from experience. Set up your FP so that when you throw the hold switch the motor is live. Probably arounf 35% at zero throttle. Now the only way to stop the motor is to throw the hold switch. Even if you dont crash. set it up so that when the stick is at full down the motor is still spinning the rotor. it will teach you to throw the hold switch to stop the rotor every time. that will prep you for needing to hit that switch in an emergency.

Also with the pitch at 40 you may not snap into the ground, but the bigger helis need a little negative pitch to come down when moving forward. You are goung to find that at 40 if you are going full forward it wil be hard to slow the bird without climbing. I have the Nano CP the MCPx anf the 450. if you can't fly the Nano and the Micro CP, you shouldnt be flying the 450. Im sure hovering ill be easy enough, but once you transition to fast forward flight you will be missing a skillset that the smaller CP helis can teach you. With a lot less cost during failure as well. Keep in mind, one crash of the 450 can easily exceed the cost of a new Micro heli. I landed on uneven ground and it caused the 450 to have a rotor strike at low RPM. That little boo boo cost $50 to repair.
Wookster is offline Find More Posts by Wookster
Reply With Quote