Thread: Discussion Walkera V400D02
View Single Post
Old Nov 14, 2012, 08:44 PM
jfranklyn is online now
Find More Posts by jfranklyn
Registered User
Joined Dec 2011
56 Posts
Hello all,
I've run into the same problem. I have an OOB v400d02 with brushed motors. I just added the hs-5055mg servos. I can't get the heli to bind unless I remove the ALE servo plug first. Anyone know a fix for this?

I spent the money to upgrade my other v400 to brushless and it works great. I was hoping to avoid spending that money again so soon, so I hope that isn't the only fix?

I went through kdean's videos to install these servos. This was a big help. I've used the rtf-heli metal servos and the 5055's were much easier to modify and fit. Plenty of room for the servo arms and wires.

Any input would be greatly appreciated. Thanks
jfranklyn is online now Find More Posts by jfranklyn
Reply With Quote