Thread: Discussion KK2.0 Board ESC Calibration
View Single Post
Old Nov 14, 2012, 08:18 PM
DYORD is offline
Find More Posts by DYORD
Registered User
Philippines, NCR, Quezon City
Joined Apr 2012
720 Posts
Discussion
KK2.0 Board ESC Calibration

I just tried calibrating my ESCs using the KK2.0 board. Followed the steps by holding the buttons 1 & 4, Tx at full throttle. Once i plugged the battery, motors start spinning at full throttle. It didn't go to programming mode. Did this couple of times to make sure that I'm holding the buttons 1 & 4. Same thing happen. I had no choice but to reprogram the ESCs one by one.
DYORD is offline Find More Posts by DYORD
Reply With Quote