Going to be running 1.3 GHz 200mw gear onboard with the SONY 600TVL SUPER HAD II camera
I've been flying the PopWing (aka Teksumo) via FPV on 2.4 10mw and 5.8 600mw but with all the electronics on the bottom. Now everything's on top and I'm going to be testing the 1.3 GHz gear and later on, a UHF.
Rehinged the ailerons with strong reinforcement tape
ESC, RX, and battery now on top, foam modded
RX is AR600, dual antennas... one antenna is cut into the foam far away from the ESC
ESC now has an additional heat sink, for those long(er) duration flights over 25 minutes
Servos (Solar A107's) now cut into the foam and lay flat
Also bought a case for the cam to keep it protected. It's a tad on the heavier side but the PopWing will handle it.