Originally Posted by Reflex1
ok. pretty easy really
DSM2 takes the "Bind conditions" as Failsafe settings
1. Confirm model controls work correctly
2. re-bind the Tx and Rx to set Failsafe (with the Tx controls at your Failsafe settings)
e.g. Throttle at Minimum.
3. remove Bind Plug and turn Tx and Rx Off
4. Turn Tx On then Rx On
confirm Failsafe is working by turning Tx Off
Common mistakes are
Low Rx voltage
Low Tx voltage
Rx supply reversed (even when the supply is Reversed the Rx LED will light)
Done this numerous times to the point of redundancy and the rx goes to WOT when tx is turned off. This is not my first or only DSMX rx.