View Single Post
Old Nov 14, 2012, 10:29 AM
Reflex1 is offline
Find More Posts by Reflex1
X-Ikarus
Reflex1's Avatar
United Kingdom, North York
Joined Feb 2003
1,739 Posts
ok. pretty easy really

DSM2 takes the "Bind conditions" as Failsafe settings

1. Confirm model controls work correctly

2. re-bind the Tx and Rx to set Failsafe (with the Tx controls at your Failsafe settings)
e.g. Throttle at Minimum.

3. remove Bind Plug and turn Tx and Rx Off

4. Turn Tx On then Rx On
confirm Failsafe is working by turning Tx Off

Common mistakes are
Low Rx voltage
Low Tx voltage
Rx supply reversed (even when the supply is Reversed the Rx LED will light)
Reflex1 is offline Find More Posts by Reflex1
Reply With Quote