Thread: Discussion Futaba FG Gold Series Thread
View Single Post
Old Nov 13, 2012, 10:27 AM
RWalker is offline
Find More Posts by RWalker
Registered User
United States, CA, Lancaster
Joined Nov 2011
223 Posts
Best Pratice to Pick up Wires

In perfecting my FrSky module upgrades on the FGs, I've found a better way to connect the module wires using servo extension leads:
1. Cut a servo lead in two, strip and tin the wires. Keep it nice and clean with twisted braids.
2. Remove the old module pins from the PCB. Just touch them with the tip of the soldering iron and they will pull out.
3. Insert the servo wires, white (PPM) red (+VCC) and black (GND) in the indicated pin holes and heat them up for a good solder joint to each hole one at a time.
3. Cut off any excess wire from the module side of the board
4. Make a solder bridge from GND to the Meter GND for the meter to function
RWalker is offline Find More Posts by RWalker
Last edited by RWalker; Nov 13, 2012 at 02:05 PM.
Reply With Quote