View Single Post
Old Nov 13, 2012, 10:01 AM
TexasClouds is offline
Find More Posts by TexasClouds
Registered User
TexasClouds's Avatar
Joined Feb 2010
2,171 Posts
i spent an hour last night trying to mount the engine. i had to releave some wood on the lower cowl block to allow room for the crankcase. i tried using some M3 blind nuts, but didn't get them aligned properly and the engine has some left trust. working on plan B to get the engine straight. lack of access below the motor mount plywood plate makes this one a booger.
TexasClouds is offline Find More Posts by TexasClouds
Last edited by TexasClouds; Nov 13, 2012 at 10:39 AM.
Reply With Quote