View Single Post
Old Nov 13, 2012, 06:29 AM
Daedalus66 is online now
Find More Posts by Daedalus66
60 years of RC flying
Daedalus66's Avatar
Canada, ON, Ottawa
Joined Feb 2006
18,357 Posts
Plugging in a servo while the receiver is powered up should not cause a problem unless the servo is faulty (which you say is not the case).

I would go back to basics, make sure your power supply (4.8 volt battery or ESC) is working properly and plugged in the right way round (the most common mistake). Also check that the bind plug is not defective (try another or check continuity).

If applying power with the bind plug in place does not produce rapid flashing of the orange light, the receiver is not functioning properly and should go back to Horizon Hobby service. No point in any further testing.
Daedalus66 is online now Find More Posts by Daedalus66
Reply With Quote