Thread: Build Log Windlord
View Single Post
Old Nov 12, 2012, 09:11 PM
jdveirin is online now
Find More Posts by jdveirin
Zeus
Joined Jul 2006
144 Posts
wing - joiner tube

The forward part of the W1 and W2 ribs made aligning the wing joiner tube easy. I glued W1 and W2 into position, shimming them for the bottom sheeting. Then, I slid the brass tube through the holes in W1 and W2 and voila, the tube was aligned as per the plans. Blocking was cut on the band saw and epoxied into place. I cut a second set at the same time to make sure it comes out the same angle on the second wing half. A 1/16" plywood web will be added front and back. W1 and W2 will be cut at the vertical laser cut line and then reattached after the forward web is in place.
jdveirin is online now Find More Posts by jdveirin
Reply With Quote