View Single Post
Old Nov 12, 2012, 05:51 PM
sonnier00 is offline
Find More Posts by sonnier00
Registered User
sonnier00's Avatar
United States, TX, Huntsville
Joined Oct 2011
257 Posts
Quote:
Originally Posted by kodak_jack View Post
The #1 rule in R/C is to cut the throttle before you hit anything. You're lucky if you don't take out an ESC if the blades stop and the motors are still under power. Stripped gears is not a problem we hear of on here.
Yes that's a hard lesson to learn if you don;t shut it all down.
I thank my gear problem was the esc's and the motors. I reprogrammed the esc's to a softer start and set the timing to high and it's not happen now. The gears where having chunks of the gears taken out and was not having any blade stikes just hard starts. The high timing I thank should take some of the low end power out of the motors???
sonnier00 is offline Find More Posts by sonnier00
Reply With Quote