View Single Post
Old Nov 11, 2012, 02:38 PM
brontide is offline
Find More Posts by brontide
Stop me before I build again!
United States, NY, Albany
Joined Sep 2012
1,320 Posts
Quote:
Originally Posted by Fidy$Trainer View Post
Guys still need little help calibrating my ESC's I've watched the video 30 times now. I never hear the two beeps like in the video.

my steps.
1) Full throttle turn on radio DX7
2) unplug M1
3) plug in battery
4) while holding button 1 and 4 i plug in M1 I see the boot up screen it says FW1.4 and some other stuff then a message saying throttle passthrough and the motors spin up. I never HEAR the TWO beeps.????? Any ideas?

Also I'm running 1.4fw and it says Throttel Passthrough it used to say calibrating ESC's with prior firmware??
Step 2 is wrong, resetting the KK is not the same as plugging in the power to the ESCs. You need to leave m1 attached, hold down the two buttons and then battery in. You may need to consult your ESC manual for specifics on beep pattern.

Please tell me you are doing this with props off or one of each motor lead detached.

If all else fails, you can do ESC calibration manually via the receiver.
brontide is offline Find More Posts by brontide
Reply With Quote