Thread: Discussion 3DHS 58" Edge 540
View Single Post
Old Nov 11, 2012, 02:20 PM
Bivens is offline
Find More Posts by Bivens
Team 3DHS / Team JR
Bivens's Avatar
United States, TN, Knoxville
Joined Apr 2010
4,531 Posts
Quote:
Originally Posted by cookci View Post
its as far forward as i can get it... I will measure to be sure.

So its not as precise as the slicks but presumably its precise enough for most fliers or is it best to keep this one to 3D only? Is there a big enough difference to justify owning an Extra 60" EXP also?
3dhs 57" extra ??

Quote:
Originally Posted by cookci View Post
I could probably gain upto another centimeter in length by pulling forward the cowl and extending using some washers the motor mount.

Do you think a cm would make any difference or is it length behind the wings which helps with precision?
Everything helps. On my edge I put the motor as far forward as I can get it and still have the cowl fit. If you'd like to try this "risk-free" for a flight, you could always tape the cowl on with blenderm or similar before drilling it for that new location.
Bivens is offline Find More Posts by Bivens
Reply With Quote