Thread: Yippee! HK Specter 1800
View Single Post
Old Nov 10, 2012, 03:37 PM
peterlngh is online now
Find More Posts by peterlngh
Registered User
Joined Apr 2012
3,222 Posts
Spinner fit.

Here's a pic of my spinner. As you can see, or not, it looks fine with a 33mm spinner. I don't think it looked bad with the 28mm spinner and I wouldn't even hesitate to use a 34-35mm spinner if that's what I had on hand. I'll also include the link to the prop/spinner I'm using. The yoke is for blades with an 8mm shoulder but I have also used blades with a 6mm shoulder by adding a couple washers.

http://www.hobbyking.com/hobbyking/s...dProduct=13173

It's not quite a warmliner but it climbs, at least, as fast as a hi-start and I'm afraid to do loops at full throttle. With the 11X6 props that I keep breaking it will hang on the prop until the torque and wind overcomes the control surfaces but even with the 10X6 it will accelerate indefinitely in a vertical climb.
peterlngh is online now Find More Posts by peterlngh
Reply With Quote