View Single Post
Old Nov 10, 2012, 12:22 PM
Grunblau is offline
Find More Posts by Grunblau
Registered User
Detroit, MI
Joined Sep 2010
33 Posts
Quote:
Originally Posted by ptxman View Post
Nice!

Dumb question, but what keeps the cut-out parts stuck to the backing board & not move around during milling? It doesn't look like that perforated (vaccum?) type I see sometimes & looks like your outer clamps are form the rectangular material blank.
Mostly the screws, but I also used tabs on a lot of the parts...
Grunblau is offline Find More Posts by Grunblau
Reply With Quote