View Single Post
Old Nov 09, 2012, 07:46 PM
Gordks is offline
Find More Posts by Gordks
Registered User
Chilliwack, BC Canada
Joined Mar 2010
1,096 Posts
Quote:
Originally Posted by koumou View Post
Attachment 5289363

Attachment 5289364

Attachment 5289365

Attachment 5289366

My motor gave up lately so I replaced it with a BC-2826/6 2200Kv. I used the motor mount that came with my Bixler to make a new one as shown in the pics. I used thin CA to hold it together and the the two sticks going through are kebab sticks.
A wonderfully simple and effective solution! It is amazing what you can do without a machine shop and aluminum if you just spend a little time thinking about it. I might have put a couple of small pieces of dowel in compression in the gap to give it four points of support, but I suppose the foam itself tends to keep it from vibrating at right angles to the two dowels anyway. I would likely been well into the land of the unnecessary.

Gord
Gordks is offline Find More Posts by Gordks
Reply With Quote