View Single Post
Old Nov 09, 2012, 03:15 PM
richie967 is offline
Find More Posts by richie967
Registered User
richie967's Avatar
Cardiff, UK
Joined Aug 2008
357 Posts
Thanks....almost there!

Quote:
Originally Posted by awmeade View Post
Good progress, I like it
Going to do a fair bit tomorrow.... including the following, in priority order

1. Cut out main gear and move 2 inches forward
2. Make a cut out to give the prop a bit more breathing area, together with tapering the fuselage a bit to allow better airflow to the propeller.
3. Browne paper new tail
4. The two carbon spa’s I am currently using to go through the wing are different lengths. 1m and 800mm. I have replaced the 800mm spa with another 1m spa. But the wings don’t quite fit all the way on. So make this fit.
5. remove extra long nose section, and possibly strengthen fuselage with the Carbon strip.

On another note, do yo know where I can get hold of a nice large robust nose wheel leg? something similar to the picture perhaps....I'd like to fit an 80mm wheel in it...

Rich
richie967 is offline Find More Posts by richie967
Reply With Quote