View Single Post
Old Nov 08, 2012, 07:39 PM
grosbeak is offline
Find More Posts by grosbeak
Illegitimi non carborundum
grosbeak's Avatar
Canada, ON, Ottawa
Joined Mar 2011
1,791 Posts
Thank you!

7. Remove the Glad Press'n'Seal
  • Grab your heat gun and set it to Pleasantly Warm
  • Starting at one end, apply a little warmth to the Press'n'Seal with the heat gun and start peeling it from the surface
  • At the edge of the design, slow down to ensure that the graphic remains on the surface
  • Continue a slow cycle of warming and peeling until all of the Press'n'Seal has been removed





8. Finish the job
  • Iron the graphic lightly, then use the heat gun to stretch out any creases
  • Wash off the surface and the graphic and you're good to go!

grosbeak is offline Find More Posts by grosbeak
Reply With Quote