View Single Post
Old Nov 08, 2012, 05:47 PM
GryphonRCU is offline
Find More Posts by GryphonRCU
Registered User
GryphonRCU's Avatar
United States, CA, SF
Joined Mar 2008
4,033 Posts
Tippy,

Make sure your hingeline is sealed.

Increase your AMPs while still on 6S with respect to motor temp and battery capability.

I also think that your motor is about a 7S max motor in this application (very capable Low KV motor).
Do not run 6.5" diameter prop on 7S. Run 7".
If you ever get a 7S, the cells need to be more capable than your current cells.

Compared to both more AMPs "and" another cell; You may currently have your motor at 60% of max Watts for single high speed passes.
Expect conservative 20MPH speed increase if you decide to push that far....possibly 25MPH increase.

Arctery and PeterM can help you more than me given their previous experiences with 22/35/1.5E (S or R? ) and 22/30/1.5SE (respectively).


I think MPI has 36mm heat sinks in 2 different lengths. The more of the motor you cover the cooler it will run. Some guys run 1 1/2 or 2 heat sinks.


Good luck,

Gryphon
GryphonRCU is offline Find More Posts by GryphonRCU
Reply With Quote