View Single Post
Old Nov 08, 2012, 05:29 PM
kahloq is offline
Find More Posts by kahloq
Registered User
kahloq's Avatar
Fort Collins, Colorado, USA
Joined Dec 2005
7,821 Posts
Since this will be a rather large vehicle when done, I will need to figure out a way to make the thing tranportable.

Everything will have to be hand made, so its not going to get completed in just a couple weeks.
However, I also have a small y-shaped aluminum frame to test out the fc board and tilt ducting ideas before installing the much larger units on the main project. So...I will make posts about the smaller test bed along the way as I scratch build the HK. The small one will be using 70mm edfs and will function basically the same...just no elaborate body.

As a side project, I also have the Hobby King y-3 tricopter with the heli canopy, but my main focus will be the big hunter killer vehicle
kahloq is offline Find More Posts by kahloq
Reply With Quote