Thread: New Product Turnigy Talon Tricopter Frame
View Single Post
Old Nov 08, 2012, 08:57 AM
TheFernMan is offline
Find More Posts by TheFernMan
Too Many Thread Subscriptions
TheFernMan's Avatar
United States, FL, Miami
Joined Jul 2012
2,236 Posts
Quote:
Originally Posted by rocketscience View Post
UGH HK specs say 3mm. I was able to (barely) get the prop adapters on. I cleaned up the burrs and using a 7/16 drill bit turned by my fingers, was able to clean up the inside.

Is 16g wire for the motor extensions a bit overkill? I feel like the ntm motors use 20g wire themselves? I may go with 20g or something smaller than 16 anyway.

I also have a mix of HK and hobbypartz lights and will run it off the balance tap for a 4S. This means I will run it off the 12V tap - ending up with a slightly uneven cell balance at the end of a flight - but shouldn't be too much. I've done this on my quad.
i ran led lights from my 3s balance plug with a 3300 nano battery and now i cant seem to balance charge all cell. theres a cell i cant balance back to normal. its like .2 volts off from the other two cells. might just be a bad coincidence though.
TheFernMan is offline Find More Posts by TheFernMan
Reply With Quote