Thread: New Product Turnigy Talon Tricopter Frame
View Single Post
Old Nov 07, 2012, 08:44 PM
rocketscience is online now
Find More Posts by rocketscience
Not a six pack
rocketscience's Avatar
USA, IL, Chicago
Joined Jul 2008
5,617 Posts
UGH HK specs say 3mm. I was able to (barely) get the prop adapters on. I cleaned up the burrs and using a 7/16 drill bit turned by my fingers, was able to clean up the inside.

Is 16g wire for the motor extensions a bit overkill? I feel like the ntm motors use 20g wire themselves? I may go with 20g or something smaller than 16 anyway.

I also have a mix of HK and hobbypartz lights and will run it off the balance tap for a 4S. This means I will run it off the 12V tap - ending up with a slightly uneven cell balance at the end of a flight - but shouldn't be too much. I've done this on my quad.
rocketscience is online now Find More Posts by rocketscience
Reply With Quote