View Single Post
Old Nov 07, 2012, 05:17 PM
LONGBIKE is offline
Find More Posts by LONGBIKE
If you cant find it Build it!
LONGBIKE's Avatar
NEAR ST. LOUIS ILL. SIDE
Joined Jan 2006
1,566 Posts
Thanks John.
I used aluminum tubing for the small ones and brass for the bigger ones, the aluminum just cuts easier, I cut them close as possible the the size i wanted and then just sand them down to equal length on a piece of sandpaper laid down on the table.
Or you can glue them in place and sand then all down at the same time with a block sander.
LONGBIKE is offline Find More Posts by LONGBIKE
Reply With Quote