Thread: Discussion Concave/convex planking.
View Single Post
Old Nov 06, 2012, 09:10 AM
epoxyearl is offline
Find More Posts by epoxyearl
Registered User
epoxyearl's Avatar
United States, MD, Elkton
Joined Oct 2011
11,017 Posts
There is no easy way to do it,because if you're doing a round,tapered,piece,each strip will be different..
There was a thread here a little while back where some one shows how to make an aluminum tapered guide to cut each strip so it fits..
It sure looked as if it would work....
Most of the planking I do is on large models,so a very slight angle is required- I usually sand,or plane,it in as I go.

Maybe someone can link you to the thread.
epoxyearl is offline Find More Posts by epoxyearl
RCG Plus Member
Latest blog entry: Airshows, and Tradition.
Reply With Quote