View Single Post
Old Nov 06, 2012, 07:06 AM
Stevedots is offline
Find More Posts by Stevedots
Registered User
Stevedots's Avatar
Medford, Massachusetts USA
Joined Feb 2008
361 Posts
Quote:
Originally Posted by KC Flyer View Post
Are you using the default elevon mix on the DX6i? That mix has well-documented problems.

Otherwise, I dial in much more aileron travel than elevator travel. But I'm a fan of expo (at least on high rates) so I can roll 3-4x/second going fast down runway or in a high speed dive.
I'm using Futaba but thanks to everyone for the suggestions. I'll try my turns again on low rates and then on high and see the difference. If it still happens on low rates then I'll try reducing elevator travel and see how that works out.

I forgot to say that during the first days flights I did have a landing that went long and I slid into one of our flight stations nose first. The flight stations are made of wrought iron! This incredible plane just bounced off with no damage at all....I forgot to check the wrought iron for damage!!

Thanks,
Steve
Stevedots is offline Find More Posts by Stevedots
Reply With Quote