View Single Post
Old Nov 06, 2012, 03:56 AM
alll is offline
Find More Posts by alll
manuLRK
Belgium
Joined Sep 2004
1,535 Posts
DroFly OCTOFLATX

Hi,
I have a DroFly MPU6050 + MS5611 + HMC5883 + Atmega32U4 from www.drotek.fr.
I try to setup an OCTOFLATX configuration (multiwii v2.1). No luck up to now, some motor outputs are dead or behaves strange. In the GUI everything looks all right!
Could you share your config.h file and other adaptations you made to make it work? Also the esc connections!
Thanks,
manu

Quote:
Originally Posted by marc von DEE View Post
hi guys,

a couple of month ago, i wrote a little bit about an octo with FCP centerplates.
after having many issues trying to flash my esc, i ordered a set of 25A at Paul' s shop.
Those are allready flashed with the simonK firmware, and are compatible with the MT 3506

configuration:
OctoflatX, FCP centerplate, 16x1 alumium booms, MT3506-25 650 kV,12x4,5 props, SimonK 25A esc, 2x 3s 2100mAh flyduino, Divide E Impera V2, BMA020, ITG3200 MultiWii_dev_20120622 .
2950g with gimbal still empty... that's an octofat...http://www.youtube.com/watch?v=WLAvwiMmLNE&sns=em

the first part of the job is done now, maiden flight was this evening
fly' s with basic setup, only P on 7, I on 0.040, and rc rate on 2.
have to tune this a bit more, but that' s ok so far.



CU, marc
alll is offline Find More Posts by alll
Reply With Quote