View Single Post
Old Nov 05, 2012, 06:54 PM
Znybar is offline
Find More Posts by Znybar
Registered User
Joined Sep 2012
392 Posts
Originally Posted by Norm62 View Post
Curious... Did you just get a piece of balsa and cut it using the foam aileron as a guide! Does the trailing edge need to be thinner than the edge closest to the wing? Or am I over thinking it?

Yeah, I think I used 4.5mm balsa sheet (seemed stiff enough for my purposes) and cut it to the same dimensions as the stock ones. I tapered the end off to reduce drag a bit, but nothing like the stock ones. I wanted them to stay stiff after all!

Basically the ones I have are just flat with thinner trailing edges.
Znybar is offline Find More Posts by Znybar
Reply With Quote