Originally Posted by dr.E
This comes from the FoamTac Site (I don't see any difference in what the reps said vs the instructions that are on the web)
I have three tubes of the original Foam Tac and a partial left. The instructions on the card say to "put Foam Tac on both pieces and allow to air dry for 10 -20 minutes then join together." I ended up with a misaligned fuselage because their was no adjustment time and the parts stuck immediately and would not pull apart. I posted this a page or two back and got a reply that you don't need to let it set 10 - 20. Then why is it in the instructions on the card? That question was not answered. I like Foam Tac and will follow the revised instructions. It just would have nice to have had better instructions from the start. I am guessing that the first batch sold to Radical RC that has the new formula but on the old purple card still has the 10 - 20 minute instructions also.