Thread: Contest Foam-Tac Contest
View Single Post
Old Nov 05, 2012, 06:22 AM
dr.E is online now
Find More Posts by dr.E
Don't cut the Yellow Wire
dr.E's Avatar
Ridgewood ,NJ
Joined Jan 2000
3,683 Posts
This comes from the FoamTac Site (I don't see any difference in what the reps said vs the instructions that are on the web)

http://www.foam-tac.com/home.aspx

Helpful Hints / Directions
HELPFUL HINTS
Less is more! Apply a thin line of Foam-Tac to surfaces; add more only if needed.
Foam-Tac's bond "welds" foam together for making invisible butt-joints & seams. Once cured, bond is stronger than the foam itself.
Great for reattaching broken ailerons.
Won't glue fingers together - not a cyanoacrylate.
Never leaves any residue on surfaces.



DIRECTIONS
All surfaces must be clean, dry, and free of dust and grease.
Remove white cap & save for storage. Screw on applicator tip & snip.
Apply a thin layer of glue to each side of materials to be joined.
Wait a few seconds and then firmly press parts together and immediately separate for 4-5 seconds more. Rejoin parts, firmly pressing surfaces together for a permanent bond.
Allow to dry for 20-30 minutes for a strong bond with a full cure within 24 hours or less.
ALWAYS REPLACE THE FLAT WHITE CAP AFTER EACH USE TO KEEP GLUE FROM THICKENING

Foam-Tac Usage.mp4 (1 min 14 sec)
!

Old_Foam-Tac.mov (2 min 36 sec)
dr.E is online now Find More Posts by dr.E
Reply With Quote