View Single Post
Old Nov 04, 2012, 05:09 PM
psguardian is offline
Find More Posts by psguardian
If I build it, it will fly
United States, NY, East Rochester
Joined Jan 2012
713 Posts
I had the spinning out of control issue, direction reversed on gyro setup.

The hk401b have been reported as being loose in the case, due to only being held in place via the wires. A few videos on it show taking it apart & removing the film from the dip switches, laying it back in the case, filling case with hot glue or silicone & putting the base back on. This eliminates vibes induced by theboard bouncing around inside the case.

Hope these two points put you on track to a steady tail.

~psguardian
psguardian is offline Find More Posts by psguardian
Reply With Quote