Thread: Yippee! HK Specter 1800
View Single Post
Old Nov 04, 2012, 01:55 AM
peterlngh is offline
Find More Posts by peterlngh
Registered User
Joined Apr 2012
3,221 Posts
Those should work well, Ed. You still might have to alter the servo tray though because they are only 2mm shorter than my HXT 900s. The pushrods on mine actually touched the bottom of the wing but not enough to stall the servos. After I realized they were touching I ground about 1/2mm off of the wire. If you look at the picture I posted you can see that the top portion of the Z-bends are flat.
peterlngh is offline Find More Posts by peterlngh
Reply With Quote