Thread: Help! Minima 6- questions
View Single Post
Old Nov 03, 2012, 03:40 PM
Bart10 is offline
Find More Posts by Bart10
Registered User
Bart10's Avatar
Poland, Podkarpackie, Mielec
Joined Apr 2010
151 Posts
Thanks again. Some time ago I have a similar situation in my another model when I have an Optima 7. I use SPC port that. I have set fail safe in neutral positions and when I have turned off the TX (I could change the trimmer a little), servo move a little in one direction and then in the other (immediately after I have turned off TX). I have set fail safe again and to date everything has been OK. Is it normal? It could predicted that servo has moved immediately but I don't think so.
Bart10 is offline Find More Posts by Bart10
Reply With Quote