View Single Post
Old Nov 03, 2012, 09:07 AM
er9xuser is offline
Find More Posts by er9xuser
Registered User
Slovenia, Ljubljana
Joined Sep 2011
1,682 Posts
Quote:
Originally Posted by p66charly View Post
hello gays
i have two question about the kk2 v1.2 firmware
the height dampening what is used for ,how it work?
about the alarm voltage ,how i will connect the battery to display the voltage,now is connected to the board by the esc,end naturally i read 0 volt.
thank you for your answere.
You must solder one wire from KK2 board it is a little hole and this cable you solder to + of battery or power distribution board.

KK2 Voltage Alarm Setup (7 min 21 sec)
er9xuser is offline Find More Posts by er9xuser
Reply With Quote