View Single Post
Old Nov 02, 2012, 10:22 PM
rob10000 is offline
Find More Posts by rob10000
Registered User
rob10000's Avatar
Joined Oct 2004
845 Posts
Originally Posted by out_of_control View Post
Great thread, gives all the info needed - but being a noob I need a little help

Any issues using Sk450 frames instead of the 1/2" square in the BOM
I like the idea of well supported motors - just been re reading the thread, looks like the arms are fine, why is there another level of frame above the arms

I make a version out of these plans for the SK450 arms, and they work great.
The plans work fine "as is" for the bottom plate and the holes even line up, but the upper one needs the arm 'stubs" widened slightly to accommodate the width of the SK arms, because the mounting holes are further apart on the top side.
rob10000 is offline Find More Posts by rob10000
Reply With Quote